9 Pin UHV Female PEEK connector to round cable assembly.
Part Number: 100040
9-Pin UHV Subminiature-C Female PEEK connector to Kapton® insulated Round/Circular cable, leads in 19" or 39" lengths.
$215.00
This is a test of the "site alert message system". (edited)
Subminiature-C Round Cable Assemblies
9 Pin UHV Male PEEK connector to round cable assembly.
Part Number: 100030
9-Pin UHV Subminiature-C male PEEK connector to Kapton® insulated Round/Circular cable, leads in 19" or 39" lengths.
$215.00
Connector to Connector Extension Cable, Female UHV Service
Part Number: 100120
2x 9-Pin Subminiature-C female connectors / Kapton insulated cable leads 19" length.
$375.00
Contact to Cable, Female UHV Service
Part Number: 100060
9x Female socket contacts / Kapton insulated cable leads in 19" or 39" lengths.
$66.00
Contact to Cable, Male UHV Service
Part Number: 100050
9 Way Circular Kapton Cable with Pins (Male) on one end, 19" or 39" lengths.
$66.00
Subminiature-C Vacuum Round Cable Assemblies
Connector to Cable Vacuum assemblies are fitted with PEEK Subminiature-C female or male connectors at one end, and nine, non-terminated, color coded Kapton insulated wires at the other. The female cable connectors mate directly onto the vacuum-side of Subminiature-C UHV feedthroughs, sub-c HV feedthroughs, or with male in-vacuum cable connectors. The cable jacket is a PEEK braid with a nominal diameter of 0.14 inches. The nine wires are Kapton® insulated 28 AWG silver plated copper conductors, stranded 7 x 0.005.
Connector to Connector Extension Cables are fitted with PEEK Subminiature-C female connectors on both ends of a 19-inch UHV Ultra-High Vacuum round cable.
Contact to Cable UHV round cable assemblies include crimped male or female contacts on one end, and nine, non-terminated, Kapton insulated leads at the other.
Caution: 'contact to cable' assemblies do not include PEEK connectors and will not allow subsequent connector installation, as wires must be threaded through connector back-piece before crimping contacts.
Features
- Subminiature-C 9-Pin Interface
- High temperature rated to 250°C
- UHV compatible construction
- Kapton® Insulated Vacuum Cables
- PEEK Connectors with Locking Screws
- Custom Solutions on Request
Specifications
| Electrical 1, 2 | |
| Voltage | 500VDC |
| Current | 5A |
| Material | |
| Connector 3 | PEEK |
| Braiding, Monofilament | PEEK |
| Insulation, Wire | Kapton |
| Wire, 7x.005 Stranded | Ag-Plated Cu |
| Vacuum Range 4 | |
| UHV, Ultrahigh Vacuum | 1x10-10 Torr |
| Temperature Range 4 | |
| Connector / Wire | -75 to 250°C |
| Notes |
- Electrical ratings are maximum test values, with feedthrough's vacuum side at ≤ 1x10-4 Torr. Feedthroughs are intended for instrumentation applications carrying low level signal voltage and current.
- For proper heat dissipation, a maximum of 20% of the pins on a feedthrough may carry the maximum pin current at any given time.
- PEEK is a polyether ether ketone thermoplastic.
- Overall assembly ratings must be adjusted to that of its lowest rated component. For cryogenic service, the lowest recommended temperature is -75°C