Home › Components

This is a test of the "site alert message system". (edited)

Vacuum Components

Kapton heater film and sheet elements Show Heating Elements for Kapton heater film and sheet elements
Heating Elements
Three ceramic standoff electrical insulators Show Electrical Standoffs for Three ceramic standoff electrical insulators
Electrical Standoffs
DuPont MOLYKOTE, Apiezon-L and Apiezon-M vacuum lubricants Show Vacuum Lubricant for DuPont MOLYKOTE, Apiezon-L and Apiezon-M vacuum lubricants
Vacuum Lubricant
Torr-Seal vacuum sealant, UHV epoxy and UHV silver-filled epoxy Show Vacuum Sealant for Torr-Seal vacuum sealant, UHV epoxy and UHV silver-filled epoxy
Vacuum Sealant
Soldering iron with three interchangeable tips and solder flux Show Solder / Accessories for Soldering iron with three interchangeable tips and solder flux
Solder / Accessories
Two rolls of Kapton tape silicone adhesive Show Adhesive Tape for Two rolls of Kapton tape silicone adhesive
Adhesive Tape
Ultrahigh (UHV) and High (HV) In-Vacuum Components

In-Vacuum Components (High and Ultrahigh Vacuum)

Accu-Glass Products, Inc. offers a large selection of vacuum components to meet the demands of ultrahigh vacuum environments.

Kapton® film Heaters provide a means of heating sample trays, cuvettes, reagent bottles, etc., inside a vacuum.  Constructed with two sheets of Kapton® film that is resistant to chemicals, oils and radiation, and have a total thickness of ony 0.008-inch.  Maximum heat output is 150ºC.  FEP adhesive used internally.  Lead wires are Teflon® insulated with a length of 12 inches.  Heater outputs 10 watts/in2 for rapid warm up.  Vacuum rated for 1x10-8 Torr and 200ºC maximum exposure temperature.  Available with or without Acrylic adhesive.

Electrical Gtandoffs made from glazed steatite provide electrical isolation and resistance to themal extremes, high-wear conditions and corrosion.

In-Vacuum Lubricants and Greases are low vapor pressure materials that are suitable for use in high vacuum applications.

High Vacuum  (HV) Sealants provide a quick, permanent vacuum seal with low outgassing.  Suitable for use in high vacuum applications.

Ultrahigh Vacuum  (UHV) Solder and Flux is available and provides a clean, positive electrical connection that does not outgas.  The melting/flow temperature is 280ºC.  It is suitable for use in ultrahigh vacuum applications.  This is an 85% gold and 15% proprietary alloy.

Kapton® tape is an adhesive tape that provides a clean, flexible electrical insulation with low outgassing characteristics.  It has a dielectric strength of 7500 VDC and a tensile strength of 30 lbs/inch-width.  It is suitable for use in ultrahigh vacuum applications.  Available with acrylic or silicone adhesive.

Click on a category below to see our available high vacuum components for purchase.