HomeSubminiature-CUHV Ribbon Cables

This is a test of the "site alert message system". (edited)

Subminiature-C Flat Ribbon Cable Assemblies

Connector to Cable - Female

Connector to Cable - 9-Pin Female

Part Number: 100110

9 Way Kapton Ribbon Cable with Sockets (Female) & Peek C-Connector on one end, 19" or 39" lengths.

$234.00
Connector to Cable - 9-Pin Male

Connector to Cable - 9-Pin Male

Part Number: 100100

9 Way (9-Pin) Kapton Ribbon Cable with Pins (Male) & Peek C-Connector on one end, 19" or 39" lengths.

$234.00
Contact to Cable - 9 Way Male (Kapton)

Contact to Cable - 9 Way Male (Kapton)

Part Number: 100240

9 Way Kapton Ribbon Cable with Pins (male) on one end. 19" or 39" lengths.

$90.00
Contact to Cable -  9 Way Female

Contact to Cable - 9 Way Female - Kapton

Part Number: 100250

9 Way Kapton Ribbon Cable with Sockets (female) on one end.
19" or 39" lengths.

$90.00
subminiature-c ribbon cables

Subminiature-C Vacuum Flat Ribbon Cable Assemblies

Connector to Cable: UHV Kapton flat ribbon cable assemblies are fitted with PEEK Subminiature-C female or male connectors at one end, and nine, non-terminated, color-coded Kapton® insulated wires at the other.  

The female cable connectors mate directly onto the vacuum-side of Subminiature-C UHV feedthroughs, sub-c HV feedthroughs, or with male in-vacuum cable connectors.  

The PEEK cable weave is made with a nominal diameter of 0.14 inches. The nine wires are Kapton® insulated 28 AWG silver-plated copper conductors, stranded 7 x 0.005.

Connector to Connector Extension Cables are fitted with PEEK Subminiature-C female connectors on both ends of a 19-inch UHV Kapton insulated flat ribbon cable.

Contact to Cable: UHV ribbon cable assemblies include crimped male or female contacts on one end, and nine, non-terminated, Kapton® insulated leads at the other.

Caution: 'contact to cable' assemblies do not include PEEK connectors and will not allow subsequent connector installation, as wires must be threaded through connector back-piece before crimping contacts.

Features

  • Subminiature-C 9-Pin Interface
  • High temperature rated to 250°C
  • UHV compatible construction
  • Kapton® Insulated Vacuum Cables
  • PEEK Connectors with Locking Screws
  • Custom Solutions on Request

Specifications

Electrical 1, 2 
Voltage500VDC
Current5A
Material 
Connector 3PEEK
Braiding, MonofilamentPEEK
Insulation, Ribbon WireKapton
Wire, 7x.005 StrandedAg-Plated Cu
Vacuum Range 
UHV, Ultrahigh Vacuum1x10-10 Torr
Temperature Range 4 
Connector / Wire-75 to 250°C
Notes 
  1. Electrical ratings are maximum test values, with feedthrough's vacuum side at ≤ 1x10-4 Torr. Feedthroughs are intended for instrumentation applications carrying low level signal voltage and current.
  2. For proper heat dissipation, a maximum of 20% of the pins on a feedthrough may carry the maximum pin current at any given time.
  3. PEEK is a polyether ether ketone thermoplastic.
  4. Overall assembly ratings must be adjusted to that of its lowest rated component. For cryogenic service, the lowest recommended temperature is -75°C